Executing the Job to write and read data in Snowflake
After setting up the Job and configuring the components used in the Job for writing
and reading Snowflake data, you can then execute the Job and verify the Job execution
result.
and reading Snowflake data, you can then execute the Job and verify the Job execution
result.
-
Press Ctrl + S to save the
Job. -
Press F6 to run the Job.
As shown below, the data is written into the table EMPLOYEE in
Snowflake, then read from this table and outputted on the console in the
Run view of the Studio.
Document get from Talend https://help.talend.com
Thank you for watching.
Subscribe
Login
0 Comments